22
23
C
A
• The carrier
MUST
be locked firmly into the convenience
base. Check by lifting up on the carrier.
•
NEVER
use this child restraint in the forward-facing
position.
•
DO NOT
use this child restraint rear-facing in a vehicle
equipped with lap belts that only lock during a sudden
stop or crash (emergency locking retractor – ELR). You
must use a seating location with a locking seat belt.
Check your vehicle owner’s manual to see if you have
lap belts with ELRs.
Installing the Convenience Base
with the Vehicle Seat Belt
DO NOT
use this child restraint if it moves more than
25 mm (1 inch) forward or side-to-side at the seat belt
path. Serious injury or death may occur. Move the child
restraint to another seating location or try to tighten
the seat belt again.
Pull the shoulder belt
C
tightly to remove all slack
from the lap portion of the
vehicle seat belt and, at the
same time, push down on
the base
A
using your full
weight. Check to be sure
the base is secured in the
vehicle seat.
Secure the convenience
base
A
to your vehicle
seat by routing the vehicle
seat belt through the
openings
B
, as shown.
A
B
LAP BELT
LAP AND
SHOULDER BELT
WARNING
WARNING
2
1
Before you begin, be sure the vehicle is
on a level surface.
IMPORTANT:
Some ELR vehicle belts can be switched so
that they lock when tightened.
It may not be necessary
to use a locking clip in these situations.
To install a locking clip, refer to p. 38.
Refer to the vehicle owner’s manual to determine which
type of belt retractor is in the vehicle.
