20
21
Place the base
A
on the
vehicle seat.
Route the lower anchor
connector harness and hook through the lower anchor
connector harness openings
B
.
• This lower anchor connector assembly system is
intended to be used
ONLY
as described in these
instructions. Serious injury or death may result from
misuse.
• In addition to these instructions, read and follow your
vehicle owner’s manual regarding installation of the
child restraint and LATCH. If there is a discrepancy,
follow your vehicle owner’s manual.
•
ONLY
use for securing convenience base to vehicle
lower anchor bars.
•
NEVER
attach two lower anchor connector hooks to
one vehicle lower anchor bar.
•
NEVER
use the vehicle seat belts when using the lower
anchor connector. Using both together can cause slack
in a sudden stop or crash.
• When not in use, the lower anchor connectors should be
securely stored in the storage area located in the
convenience base (see page 37). Keep out of reach
of children.
•
ALWAYS
be sure that the lower anchor connectors are
fully engaged onto the vehicle anchor bars by pulling
hard on the lower anchor connector harness. If they are
not totally engaged, the lower anchor connector system
will not secure your child restraint. Serious injury or
death may result.
•
DO NOT
use this child restraint if it moves more than
25 mm (1 inch) side-to-side or front to back at the
vehicle belt path. Serious injury or death may result from
poor installation. If you cannot tightly secure the child
restraint, try again or move it to another location.
• This child restraint
MUST
face the rear of the vehicle.
• The carrier
MUST
be locked firmly into the base.
Check by lifting up on the carrier.
•
NEVER
use this child restraint in the forward-facing
position.
Installing the Convenience Base
with the Lower Anchor Connector
Assembly System
Refer to your owner’s manual to locate the
lower anchor bars on your vehicle seat.
Attach the right hook
C
to the right anchor bar
D
and
the left hook to the left anchor bar.
DOUBLE CHECK
that the hooks are fully engaged by pulling hard on the
lower anchor connector harness.
B
2
E
F
A
1
D
C
WARNING
Before you begin, be sure the vehicle is
on a level surface.
Using your full weight, push the base firmly into the
vehicle seat, while pulling up on the strap
E
to tighten.
Make sure the lower anchor connector harness is
tight.
If you can move the child restraint more than 25 mm (1
inch) side-to-side or front to back at the vehicle belt path
F
, the harness is not tight enough. You will need to try
again or find another location for your child restraint.
DO NOT
use this child restraint if it moves more than 25
mm (1 inch) side-to-side or front to back at the vehicle
seat belt path. Serious injury or death may occur. Move
the child restraint to another seating location or try to
tighten the lower anchor assembly again.
WARNING
