70
71
In vehicles
with a
lap/
shoulder belt
,
DO NOT
route
the shoulder belt
through the belt
slots.
LAP BELT
LAP/ SHOULDER BELT
IMPORTANT:
Some ELR vehicle belts can be switched so that
they lock when tightened. It may not be necessary to use a
locking clip in these situations. To obtain and install a locking
clip, refer to p. 76. Refer to the vehicle owner’s manual to
determine which type of belt retractor is in the vehicle.
Installing the Carrier
WITHOUT the Convenience Base (cont.)
Route
ONLY
the
lap
portion
of
the vehicle seat
belt through the
vehicle belt slots
on the carrier,
then fasten
buckle.
Vehicle Shoulder
belt must be
above the
polished area,
NOT
under the
child restraint.
Click!
Click!
Instead, put the lap belt through
the belt guides, then wrap the
shoulder belt around the back as
shown,
then fasten buckle.
2
Installing the Carrier without the Convenience
Base (cont.)
•
NEVER
use this child restraint in forward-facing position.
•
DO NOT
use this carrier if it moves more than 2.5 cm
(1 in.) side-to-side or front to back at the vehicle belt
path. Serious injury or death may occur. Move the child
restraint to another seating location, or try to tighten
the vehicle belt again.
The vehicle belt must be as tight as possible. Put your full weight
into the seat as you tighten the vehicle belt. If you can move the
child restraint more than 2.5 cm (1 in.) side-to-side or front to
back at the vehicle belt path, the vehicle belt is not tight enough,
and you need to try again.
T
IP
!
T
IP
!
Installing the Carrier
WITHOUT the Convenience Base (cont.)
Push down on the bottom of the
seat using your full weight.
Shoulder belt
routes above
the handle on
the opposite side
of seat.
3
WARNING!
DEATH or SERIOUS
INJURY can occur.
