11
its place revolving clockwise. It is enough to turn the sensor tight manually for pressurization. Do
not use with this the tool type of pliers.
2. Press the right button. The message greeting will appear of the screen:
“Praktik ER-6 Pro2 Lucky fishing”,
which further on will be moved to the left on the screen.
ATTENTION!
If the sensor is not screwed tightly enough in the battery compartment, then the on the
display will appear a warning message “SENSOR?”. The same message will appear if a
cable is damaged.
After installing the batteries, it is recommended that you restart the device, so it will return
to the factory settings. Press and hold the left button and then press the right button for 1-
2 seconds. The message “OK” will appear on the display, and the following factory
settings will be installed:
–
scaling:
image auto-scaling mode;
– amplification:
12 (from 28 units);
– screen scale for its manual selection mode:
7 meters;
– screen view:
fish definition mode and window RTS;
–
fish identification and sound:
are on;
– near bottom layer depth in “zoom” mode:
2 meters
- dead zone:
05-1 meter
“Winter/Summer” mode:
summer
Resetting can be made in the different time, but only when the device is turned off.
Note:
if battery was inserted earlier, then it is necessary to press the right button once to turn on
the sonar. All previously installed modes by doing so are saved.
3. Put the sensor into the water with assistance of the cable. It is desirable to put the sensor
fully below the ice edge in winter to avoid extreme cooling of the battery and offset of noise signal
Summary of Contents for Praktik 6 Pro 2
Page 37: ...37...
