M 2700 / MD27
Insert the memory card as indicated by the icon into the slot until the card totally inside.
To remove the memory card, gently press the edge of the memory card until it pops out.
When the device is power on without TF Card, the red and blue lights flash 4 times, and the device
will be power off.
The TF card must be 8GB or above, and the format is FAT32. NTFS cannot be used normally. Data
cannot be saved normally less than 8GB. If 64GB or 128GB card is used and the card is not FAT32
format, the device will automatically format the card when it is turned on. Please pay attention to data security.
3)
Power on & power off
On: press the power button for 2 seconds.
Off: press the power button for 4 seconds to turn off the device.
After power on,the blue light is on, and the device is in standby mode.
720P Video
In standby mode, the blue light is on, and the device is in 720Pvideo mode. Click the power button once, the blue light
flashes 3 times, and the device enters into the video mode. There is no indicator light . During recording , click the power
button once to stop and save the video, and the blue light is on,the device returns to standby mode.
One paragraph,5 minutes, support loop recording.
720P Video motion sensor
When the device is in 720P video mode (the blue light is on), press the R button ② for 3 seconds, the red light will
flash 3 times, the red and blue light will go out and the device will enter the 720P motion detection video mode.Once it
detects any moving objects within the range, the red and blue lights flash once to enter the video; after 5 minutes, the
video is automatically saved and back to the detecting state.(No light is show)
During detecting state, it detects any moving objects, the red and blue flash once will enter the video again. (Click any key
once to exit the motion detection video mode)
1080P Video
In the standby mode after power on, click the R button ② once, the red and blue lights ③ will be on at the same me,the
device is in 1080P video mode. Then click the power button ① once, the blue light ③is on ,the red light flashes3 mes,
and the red and blue lights ③ will be off at the same me to enter the video mode.
During recording process, click the power button ① once to stop and save the video, the red and blue lights ③ will be on
at the same time, and back to the standby mode.
One paragraph,5 minutes, support loop recording.
1080P Video motion sensor
When the device is in 1080P video mode (red and blue lights ③ are on), press R button ② for 3 seconds, the red light
③ will flash 3 mes, and the red and blue light ③ will go out. Once it detects any moving objects within the range, the
red and blue lights flash ③ once to enter the video; a er 5 minutes, the video is automatically saved and back to the
detecting state.(No light is show)
During detecting state, it detects any moving objects, the red and blue flash ③ once will enter the video again. (Click any
key once to exit the motion detection video mode)
Photo
In the standby mode after power on, click the R button ② twice, the red light ③ is on, and the blue light is off. In this
mode, click the power button ① once, the red light ③ flashes once, generate a picture and save it. To continue taking
photos, click the power button ① again.
The device will switch the infrared night vision light automatically. It will turn on automatically when the light is dark.
Please pay attention to the surrounding environment.
