Eurotherm 3204i, User Manual

Page: 44 / 140

42 Part number HA029005. Issue 2.0 May-06.
5.3.7 Calibration Using a Digital Input
A digital input may have been set by selecting ‘Z’ in
the quick codes (section 4.1) to allow the transducer
to be calibrated automatically via an external source
such as a switch or pushbutton. In this case pressing
the button will have the same effect as selecting
yes
in 3 above.
5.3.7.1 Fail
Fail will be displayed in any of the above calibration
procedures if the calibration is not possible. For
example, the input shows Sensor Break or is out of
range or the transducer or load cell is not connected
correctly. It is necessary to correct the fault and start
the procedure again.