28 Part number HA029005. Issue 2.0 May-06.
4.1.1
To Re-Enter Quick Code Mode
If you need to re-enter the ‘Quick Configuration’
mode this can always be done as follows:-
1.
Power down the indicator
2.
Hold
button down and power up the
indicator again. Keep the button pressed until
you are requested to enter a passcode.
3.
Enter a passcode using the
▲
or
▼
buttons. In a new indicator the passcode
defaults to 4. If an incorrect passcode is
entered you must repeat the whole procedure.
☺
Parameters may also be configured using a
deeper level of access. This is described in the
3200i Engineering Handbook Part No. HA029006.
This may be downloaded from
www.eurotherm.co.uk
.
4.2
Pre-Configured Indicator or
Subsequent Starts
A brief start up sequence consists of a self test in
which all elements of the display are illuminated and
the software version number is shown.
The indicator will briefly show the quick codes
during start up, then proceed to
Operator Level 1
.
You will see the display shown below. It is called
the HOME display.
☺
If the Quick Codes do not appear during start up,
this means that the indicator has been configured in
a deeper level of access, see previous note. The
quick codes may then not be valid and are therefore
not shown.
32h8i example
Process Value
Message Centre
Status Beacons
Summary of Contents for 3204i
