Eurotherm 3204i, User Manual

Page: 26 / 140

24 Part number HA029005. Issue 2.0 May-06.
4. Switch On
4.1 New Indicator
If the indicator is new and has not previously been
configured it will start up showing the ‘Quick Start’
codes. This is a built in tool which enables you to
configure the input type and range, the output
functions and the display format.
!
Incorrect configuration can result in damage
to the process and/or personal injury and must be
carried out by a competent person authorised to do
so. It is the responsibility of the person
commissioning the instrument to ensure the
configuration is correct
The Quick Start code consists of two
‘SETS’ of five characters. The upper
section of the display shows the set
selected, the lower section shows the
five digits which make up the set.
Adjust these as follows:-.
1. Press any button
.
The first character will change
to a flashing ‘-‘.
2. Press
▲
or
▼
to change the flashing
character to the required code shown in the quick
code tables –see next page. Note: An
x
indicates that the option is not fitted.
3. Press

to scroll to the next character.
☺
You cannot scroll to the next character until the
current character is configured.
☺
To return to the first character press .
When all five characters have been configured the
display will change to
rng.hi followed by rng.lo
which allows range high and low limits to be set.
The next press of

will select Set 2. Adjust each
character as described for Set 1.
When the last character has been entered press

again, the display will show . Continue to
press

if you wish to repeat the above quick codes
or press
▲
or
▼
to if you are satisfied
with the quick codes . The indicator will then
automatically go to the operator level