2009
EUROTECH USER MANUAL
VoIP
2
All
™
Series: 8
❘
16
❘
24 Channel Gateway User Manual
23
Dialing Settings
The 'Dialing' parameters are:
•
‘Wait for Dialing’ - The time, in seconds, from the start of the dial tone the VoIP
2
ALL
will wait for the first digit to be dialed. After that time the VoIP
2
ALL will close the
voice channel.
•
‘Last Digit Timeout’ - The time, in seconds, the VoIP
2
ALL will wait between the last
digit dialed and the calling of that number.
•
‘No Replay Timeout’ - The number of seconds with no answer the Gateway will wait
before calling the next number (In Priority or Cyclic mode).
•
‘DISA’ - Is the number of seconds each DISA number will stay in memory.
•
‘Debug Level’ - Is the amount of detail to be shown on the Debug Screen. This level
usually should be set at 0, so the Gateway will not send unnecessary debug lines to PC
software.
•
'Restart Call' – When enabled allows consecutive VoIP calls. Before the end of a call
from the cellular to VoIP, press * to receive a dial tone that enables you to call another
VoIP number.
•
When done setting, press ‘Save’ to activate all the changes.
Changing the IP Address of the Gateway
The VoIP
2
ALL Gateway is connected to the net via one IP Address allotted to 3 Ports: 2007
(Gateway’s IP Port), 2008 (SIMs Port), and 2009 (Internal SIM Server Port). Changing the
VoIP
2
ALL’s IP address will change the IP address for the Gateway and the internal SIM Server.
1. Connect to the VoIP
2
ALL Gateway with the current IP address port 2007.
2. Open the VoIP window; select the ‘General’ tab.
3. In the ‘IP Address’ box enter the new IP address for the Gateway.
4. If needed, set up the Default Gateway and the Subnet Mask.
5. Press Save.
6. Wait one minute for the configuration to be saved in the xml files.
7. Disconnect from the Gateway.
8. Restart the Gateway, wait 30 seconds for initialization, connect with new IP address.
All manuals and user guides at all-guides.com
