00111950.DOCX, Version 1.1
26/32
Notes:
•
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
•
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
•
Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
DMX operation
Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with max. 10 control channels.
However, it can also be switched to a mode with 2, 5 or 10 channels if different functions are required. To be
able to operate the device with a DMX controller, the DMX starting address must be set for the first DMX
channel. The starting address depends upon which DMX controller is being used. Please refer to the
controller’s documentation.
1 Press the
MENU
button so many times until
DMX
appears on the display. Confirm with the
ENTER
button. The display next shows
dXXX
, please confirm again with
ENTER
.
2 The display then indicates
2 CH
(2 DMX channels),
5 CH
(5 DMX channels) or
10 CH
(10 DMX
channels). Use the buttons
UP
and
DOWN
to select the desired number of DMX channels. Confirm with
the
ENTER
button.
3 For the DMX start address press the
MENU
button until
dXXX
is shown on the display. Use the buttons
UP
and
DOWN
to set the address. Confirm with the
ENTER
button.
4 The red LED next to the display will blink when DMX signals are being received. If no control signals are
available, the red LED next to the display will not blink.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
2-Channel-Mode
Channel
Value
Function
1
MIX SHOW
000 – 005
No function
006 – 022
Program 1
023 – 040
Program 2
041 – 058
Program 3
059 – 076
Program 4
077 – 094
Program 5
095 – 112
Program 6
113 – 129
Program 7
130 – 147
Program 8
148 – 165
Program 9
166 – 183
Program 10
184 – 201
Program 11
202 – 219
Program 12
220 – 237
Program 13
238 – 255
Program 14
2
SPEED
000 – 250
Increasing
251 – 255
Sound control
Summary of Contents for LED Multi FX Laser Bar
Page 1: ......
