00111950.DOCX, Version 1.1
23/32
4
Secure the device with a safety bond or other secondary attachment. This secondary safety
attachment must be sufficiently dimensioned in accordance with the latest industrial safety
regulations and constructed in a way that no part of the installation can fall down if the main
attachment fails. An appropriate eyelet is mounted on the device for fixation of the safety rope.
Fasten the safety rope in such a way that, in the event of a fall, the maximum drop distance of the
device will not exceed 20 cm.
5
To align the device, release the fixation screws at the mounting bracket, adjust the desired
inclination angle and retighten the fixation screws.
6
Make sure not to point the laser beams at highly reflective surfaces such as mirror balls, windows
and shiny objects. As a precaution, remove or cover up highly reflective objects in order to avoid
laser reflections.
7
After installation, the device requires inspections periodically to prevent the possibility of rot,
deformation and looseness.
CONNECTIONS
DMX512 control
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1 Connect the output of your DMX controller to the DMX input DMX IN of the light set with a DMX cable.
2 Connect the DMX output DMX OUT of the light set to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3 At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4 If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
XLR connection:
Connection to the mains
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the mains cable to a grounded mains socket. Thus the unit is switched on.
2 To switch off the unit, disconnect the power plug.
3 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
Projector 3
Starting address 21
DMX-512 Controller
120 Ohms
Projector 1
Starting address 1
Projector 2
Starting address 11
Summary of Contents for LED Multi FX Laser Bar
Page 1: ......
