00116794, Version 1.0
37/56
5. Press
TAP/DISPLAY
to switch between 8-channel and 16-channel mode.
The display shows either ‘ASSXX XX | X/Y 08CH’ or ‘ASSXX XX | X/Y
16CH’.
8-channel mode: You can assign the PAN/TILT movement for 24 scanners.
In 8-channel mode, you can save PAN/TILT for page A and page B.
16-channel mode: You can assign the PAN/TILT movement for 12 scanners.
In 16-channel mode, you can save PAN/TILT only for page A or page B.
6. If necessary, you can use
PAGE SELECT
to switch between levels Page A
and Page B.
7. While you keep
MODE
pressed, press the
SCENES
button. All LEDs should
flash briefly and thus indicating that the DMX channel has been assigned.
The button SCENES 1 stands for DMX channel 1, SCENES 2 for DMX
channel 2 and so on.
8. Repeat steps 3 – 7 to reverse the pan/tilt channels of further scanners.
Assigning the Fade Function
The fade function can be assigned to all control channels or only to the pan and tilt channels. This is
particularly useful e.g. when the mirror or moving head movement should be carried out slowly, however, the
gobos and colors are to change quickly.
1. Switch off the controller.
2. Keep the two buttons
MODE
and
TAP/DISPLAY
pressed simultaneously and
switch on the controller. After 2 seconds, the controller enters fade time
mode selection.
3. Use the button
TAP/DISPLAY
to select the setting
ALL CH FD TIME
if the
fade function is possible for all control channels or select ONLY X/Y FD TIME
if it is only possible for the pan and tilt channels.
4. Keep the two buttons
MODE
and
TAP/DISPLAY
pressed simultaneously to
memorize your setting. To confirm the memory procedure, all LEDs of the
controller flash three times.
