164
4.2. Temperature Monitor
FPGA die temperature sensor
All Coaxlink cards embed a temperature sensor on the FPGA die.
When the
TemperatureSensorSelector
feature of the Interface Module is set to
Grabber
, the
Temperature
feature of the Interface Module reports the FPGA die temperature expressed in °C.
The user application is invited to check regularly the FPGA die temperature to ensure that the
board operates within the specified operating limits.
See also:
"Environmental Conditions" on page 161
FPGA die temperature warning
Applies to
1
When the measured FPGA die temperature reaches
87°C
, these Coaxlink cards post a
"FPGA
temperature is too high"
Memento message.
The
"FPGA temperature is too high"
message is sent repeatedly every second until the measured
temperature decreases below 83°C or increases above 103°C.
TIP
Operation is still possible but is not recommended!
WARNING
When such event occurs, the user is invited to check and, possibly, improve
the card cooling in the host PC!
1
3621 Coaxlink Mono CXP-12
,
3621-LH Coaxlink Mono CXP-12 LH
,
3622 Coaxlink Duo CXP-12
and
3622-LH Coaxlink Duo CXP-12 LH
.
Coaxlink
Hardware Manual
