EunSung HydraBeauty, Operator'S Manual, Page: 22 / 28

HYDRABEAUTY 22
NOTE
1. For the first treatment after the installation of the device, clean the device with cleansing
mode before using. Then, set the solution quantity and suction level to the maximum level
(solution level 3, suction level 5). Then, attach the tip to the back of the hand and set it for
approximately 2~30 seconds to ensure smooth circulation of the required solution.
2. When the step of treatment need to be changed, set all the levels to maximum and attach
the tip to the back of the hand for about 10-15 seconds, and set the tip to the level to be
used.
5. How to use
6. How to use aqua handpiece
Start the procedure by placing the aqua handpiece tip exactly close to the skin as shown below.
-Correct- -Incorrect-
5.4 The way to use the device
5.4.3 Aqua peeling mode
7. Cleansing mode
Hydrabeauty offers auto cleansing mode. Choose the ‘C’ mode on the screen which is aqua peeling.
Set the vacuum and solution flow lever to the maximum level and push the start button, then the auto
cleansing mode will be started for 1min. At this moment, Aqua handpiece should be covered with cap.
-Remove the tip- -Applying cap- -Correctly applied-