Operating Instructions Bus Module
MBM-PN-..-MLI-… (PROFINET)
24
(translation of the original operating instructions) MAN20001572-01-07/22
The individual data blocks or bits are always combined in the same sequence as the system layout. Here the counting is
always started at the bus module (1) and then continued from the first to the last modules on a line. If there are two lines,
the complete first line on ML1C (2…4 in the figure below) is counted first and then the complete second line on ML2C (5…7
in the figure below). Submodules in a module are counted immediately after the module in which they are inserted before
the count continues with the next module. For submodules, the SLOT number defines the sequence.
The following figure is intended to clarify the counting sequence. In chapter
11.8. Configuring and setting parameters for
modules and submodules On page 27
, it is explained again in detail how this aspect functions.
1
2
3
4
5
6
7
ML2C
ML1C
