Etrel INCH LITE, Quick Start Manual

Page: 8 / 12

6 | 10
mounting bracket so that the holes will be marked at the
correct positions when used.
If power supply cables come through the wall, a hole for
the power supply cables needs to be drilled first.
1-a
You should drill the hole in the position shown on the
picture. The hole should be big enough to manage the
cables after they are pulled through.
1-b
Drill 9 holes for screws and insert the anchor screws in
each hole.
A2
Power Supply Cable Preparation
Pull the power supply cable through the drilled hole in
the wall if the cables need to go through the wall. If
cables are connected to the charging station from above
or below, enough length of the cable should be
provided. Extra cable length available for the installation
should be around 40 cm.
Align holes of the mounting bracket with the drilled
holes and tighten the screws using Phillips-head
screwdriver.
B2
Alternative Power Supply Cable Preparation
When supply cables come from below the station, the
charging station will allow easy insertion into the
connection area. Extra cable length available for the
installation should be around 40 cm.
B2-a
If cable will be routed to the back of the charging station
from above, a cable raceway as shown on the picture
should be installed. Wall spacers (available separately)
need to be installed in this case. They should be screwed
into the holes as shown.
3
Removal of Maintenance Doors and Cable Gland Plate
On the backside of the charging station screw off the
back-maintenance door and side maintenance door. You
will need a Phillips-head screwdriver and hex screwdriver
or key, depending on the type of charger’s service doors.