ETNA FIV760RVS, Instructions For Use Manual

Page: 64 / 72

EN 30
Fault list
If you are uncertain about whether your appliance is functioning
properly, this does not automatically mean there is a defect. Try to deal
with the problem yourself first by checking the points mentioned below
in the table or visit our website ‘www.etna.nl’ for more information.
Problem with the hob Possible cause Solution
The fan runs on for several
minutes after the hob has been
switched off. The hob is cooling down. Normal operation.
A slight smell is noticeable the
first few times the hob is used. The new appliance is
heating up. This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
The pans make a noise while
cooking. This is caused by the energy
flowing from the hob to the
saucepan. This is normal for certain
saucepans, particularly at
high settings. This does not
harm the pans or the hob.
You have switched on
a cooking zone, but the display
keeps flashing. The pan used is not suitable
for induction cooking. Use a good pan.
A cooking zone suddenly
stops working and you hear
a signal. The preset time has ended. Press any button to switch
off the signal.
The hob is not working and
nothing appears in the display. There is no power supply due
to a defective cable or a faulty
connection. Check the fuses or the
electric switch (if there is no
plug).
A fuse blows as soon as the
hob is switched on. The appliance is incorrectly
connected. Check the electrical
connections.
The symbol appears in
the display after you have
switched on a cooking zone.
The pan you are using is not
suitable for induction cooking
or has a diameter of less than
12 cm. See chapter ‘Pans for
induction cooking’.
Fault code F00. The control panel is dirty or
has water on it. Clean the control panel.
Fault code F0 ... F6 and FC. Defective generator. Contact your service centre.
Error code F7. The ambient temperature is
not good. Switch off all heat sources
in the vicinity of the cooking
plate.
FAULTS