Eteros TRIMINATOR XL, User Manual

Page: 10 / 27

TRIMINATOR XL DRY OWNER'S GUIDE
10
YOUR NEW TRIMMER SETUP
UNPACKING
TOOLS REQUIRED
• Machine Body, qty (1)
• Floor Stand, qty (1)
• Pull Pin, qty (1)
Triminator Dry comes in two separate boxes and requires basic assembly.
Upon unpacking you should have the following components:
• 3/4” wrench
• 7/8” wrench
• 5/16 hex wrench (allen wrench)
1. To begin, unpack the machine body and floor stand from the packaging
2. Set the machine body in the vertical position with the motor facing up and the drum opening on the floor
3. Remove the wheels from the inside of the floor stand by unscrewing the bolts. Next, reinstall the wheels on the
outside of the floor stand.
4. Roll the floor stand towards the machine body and align the bolt holes in the floor stand with those in the machine
body, insert and tighten the screws.
5. Lift the floor stand slightly so that the wheels are slightly elevated from the floor. Next begin to screw the pull pin into
the pull pin hole, and elevate or lower the floor stand until the pull pin holes and pull pin align. Tighten the pull pin.
6. Verify all screws are tight and pull pin is securely in a pull pin hole.
7. Rotate the machine up until it sits in the orientation.