Eteros TRIMINATOR XL, User Manual

Page: 15 / 27

15
Turn the Triminator Dry motor timer switch clockwise until the switch is aligned with the desired trimming duration.
To stop the Triminator in an emergency, or at any other time, turn the motor switch to the OFF position.
Disconnect the trimmer’s power cord.
STARTING THE MACHINE
STOPPING THE MACHINE
DISCONNECT POWER CORDS
NOTICE
Be sure to hold the plug when disconnecting the power cord from the electrical outlet. Do not disconnect
by pulling on the power cord.
Remove clear end cap from front of drum. Pull out Pull-Pin and pivot drum into a vertical and upward facing position. Load
dried, prepped, untrimmed plant material into the drum. For best efficiency run batches of similar material.
Pull out Pull-Pin and pivot Drum into a horizontal position. Turn machine ON and allow to run for 1-15 minutes. Check
material every 2-5 minutes. For a closer trim, continue running the Triminator Dry until desired trim is accomplished.
Empty Drum: Once desired trim is accomplished, remove clear end cap, position separate container (not included) to
capture processed material, pull out Pull-Pin and pivot drum to a downward facing position. Processed material will be
deposited in the container when correctly positioned.
Empty Trim Bin: Toggle black tabs on front or back of machine to a horizontal orientation. Slide Trim Bin out of slots, empty
bin and replace.
TRIMMING PLANT MATERIAL
LOAD
RUN
EMPTY