Lamp Socket Assembly
7
7:
Install the bushing cup (5) into the housing socket casting (1) as shown in
Figure 5
. The cup
should slide smoothly up and down, but not side to side.
8:
Insert the threaded end of the index hub (6) through the holes in the bushing cup and the back
of the housing socket casting (1).
9:
Slide the X-Y knob (3) over the exposed index hub bolt (6), then insert the wave washer (14) on
the bolt and secure with the 9/16 hex nut (13). Hand-tighten the X-Y knob (3).
10:
Insert the knurled head screw (11) through the housing socket casting (1) as shown in
Figure 6
.
11:
Install the ground spring (21) onto the screw and secure it with the Southco flat retaining
ring (12). Install the Southco ring with its prongs away from the casting.
12:
Lay the leads in the bottom half of the cable clamp (located in the housing socket casting [1]),
making sure that the cable insulation jacket extends slightly past the screw holes in the housing
socket casting. Then, route the wires as shown in
Figure 7
.
13:
Install the top half of the cable clamp (15) and secure it with the two screws (16). Tighten the
screws alternately to ensure a solid connection.
Note:
Install the wave washer with the upward curve toward the hex nut.
Note:
Use pliers to straighten the Southco retaining ring (12) if it bends when you install it
on the bolt.
CAUTION:
You must follow the wire routing diagram to ensure that the socket leads do
not interfere with the lamp focus mechanism.
5
1
6
14
13
3
Figure 5
11
15
1
22
21
12
Cable Clamp in
Housing
16
8
4
Figure 6
Figure 7
Brown wire
Green/Yellow
wire
17
26
9
Safety wire
Blue wire
Green/Yellow
wire
Summary of Contents for Source Four CE 405
Page 34: ...30 Source Four CE Assembly Guide ...
Page 35: ...Lens Tube 90 31 ...
