8
Source Four CE Assembly Guide
14:
Using the four screws (24), attach the handle (23) to the lamp socket assembly. See
Figure 2
.
15:
Place the compression spring (8) on the protrusion on the inside of the index hub. See
Figure 6
.
16:
Insert bolt (17) through spring (8) and through the index hub (6) of the housing socket (1), joining
the two castings as shown in
Figure 6
. Make sure that the wires are not pinched between the
two pieces.
17:
Before proceeding, check again to make sure that the wires are still positioned as indicated in
Figure 7
. Adjust if necessary.
18:
Press the two castings together firmly so the bottom of the light baffle (2) sits on top of the cable
clamp (15), then install the Z knob (4). Hand-tighten the knob all the way to the right. See
Figure 6
.
Note:
Make sure that the top edge of the cable clamp is even with the edge of the socket
to prevent interference with lamp focus movement. Make sure that the insulation
jacket is not pinched.
CAUTION:
You must install the Z knob as described above to ensure proper lamp focus
travel.
Summary of Contents for Source Four CE 405
Page 34: ...30 Source Four CE Assembly Guide ...
Page 35: ...Lens Tube 90 31 ...
