6
Source Four CE Assembly Guide
Assembling the Lamp Socket
Tools Required:
• Open-end adjustable wrench or a 7/16” (11 mm) socket
• Needle-nose pliers
• #2 Phillips screwdriver
1:
Set the crossbar of the retainer clip (25) under the two hooks on the clip bracket as shown in
Figure 3
.
2:
Place the Tinnerman clip (18) over the retainer clip crossbar between the two hooks and press it
down firmly until it snaps into place.
3:
Insert the bolt (17) through the light baffle socket casting (2). See
Figure 4
.
4:
Install the green and yellow ground wire assemblies (19 and 22) on the bolt (17) with the prongs
on the crimped connectors toward the casting. Run both wires through the indent in the lip
around the bolt hole. Secure with nut (10) and tighten securely (6.7 Newton meters).
5:
Place the socket assembly (9) into the light baffle socket casting (2). Be sure it is well seated.
6:
Install the lamp retainer spring (7). The lamp retainer spring secures the socket. Insert the spring
one end at a time, making sure that the rectangular slot in each side of the spring seats on the
corresponding tab in the casting. See
Figure 4
.
Note:
If the spring does not seat correctly, coax it into place with a screwdriver or needle-
nose pliers.
18
25
Figure 3
18
17
2
22
19
25
9
7
10
Figure 4
28
Summary of Contents for Source Four CE 405
Page 34: ...30 Source Four CE Assembly Guide ...
Page 35: ...Lens Tube 90 31 ...
