Installation and DMX Profiles
15
Accessory Installation
Accessories, such as grid louver, half shield, and lenses, are installed on the front of the fixture without
compromising the integrity of the water-tight seal. Secondary lenses are secured with the trim ring and
can be rotated while they are on the fixture, allowing you to focus the beam precisely.
For detailed information, refer to the following accessory installation instructions that are packaged
with the accessory.
•
D40/D60 XTI Grid Louver Installation Instructions
•
D40/D60 XTI Half Shield Installation Instructions
•
D40/D60 XTI Secondary Lens Installation Instructions
Figure-1.2 Trim Ring and secondary lens installation.
Installation on a Permanent Base
Install on a suitable, rigid, permanent base with secured bolts. This can include poured concrete pads
on the ground or a solid structure such as on top of a concrete wall. For mounting, use the full-sized
template that is included in the installation instructions or download the template at
www.etcconnect.com.
Refer to the
D40/D60 XTI Installation Instructions.
Installation on a Pole
A Single fixture or Twin fixture pole mount is used to attach the D40/D60 XTI fixture to a pole. The
Single fixture pole mount fits nominal 2-3/8 inch poles and the twin pole mount fits nominal 4 inch
poles. Both mounts can be rotated for focusing. The twin mount allows you to attach two fixtures side-
by-side on one pole.
Refer to the
D40/D60 XTI Pole Mounts Installation Instructions.
WARNING:
Make sure all accessories are securely in position before installing the
fixture.
Trim Ring
