ETC Installation Guide
ColorSource Linear Pearl v1.7
ColorSource Linear Pearl v1.7
Page 7 of 20
ETC
Powering up
1:
Press any button to wake the display. The display shows the DMX
address. See
Setting the DMX address
on
page 8
.
2:
Press the Mode button to access the Presets menu. See
Setting presets
on
page 14
.
Adjusting the tilt
The fixture can be tilted up and down as needed.
1:
Loosen, but do not remove the two trunnion locking knobs.
2:
Tilt the fixture to the desired angle.
3:
Tighten the trunnion locking knobs.
User interface
The user interface allows you to set the start
address of the fixture, access the stand-alone
presets, set the DMX control mode, and set the
Grouping mode (Linear 2 and Linear 4 fixtures
only).
• After 5 seconds of inactivity when DMX is
present, the display goes dark.
• The DMX address will blink when no DMX
is present and a preset or sequence is not
active. The inactivity time-out is disabled
while in a data loss state.
Power and data
connectors are
paired on each
side to facilitate
daisy-chaining
Up and Down
buttons
User interface
(display)
Mode button
Grouping button
and LED indicators
Linear 2 and Linear 4
Linear 1
shown
