ETC Installation Guide
ColorSource CYC v1.7/v3.1
Re-record Presets
1. Using DMX, set the desired levels for the new preset.
2. Press the Mode button to access the Presets/Sequences menu.
3. Press the Up button or Down button to navigate to the preset
number that you want to re-record.
4. Press and hold the Mode button for 3 seconds to confirm the
preset selection. The user interface will show a 3-second
countdown. The preset number blinks once to confirm that the
preset has been recorded.
Note:
When the fixture is in Direct mode (
dir
) or 1-channel
mode (
1ch
), you cannot re-record presets.
When you re-record presets with the fixture in RGB mode (
rgb
),
the intensity is set to full and the strobe is turned off.
See
Change the DMX Control Mode on page 5
Adjust the Intensity of Presets
1. Ensure that DMX data is not present.
2. Press the Mode button to access the Presets/Sequences menu, and
then press the Up button or Down button to select the preset that
you want to edit.
3. Press and hold the Mode button for 3 seconds. The display shows
L:
followed by either an intensity level from
0
–
99
or
FL
for full.
4. Press the Up button or Down button to change the intensity level of
the preset in real time.
5. Press the Mode button to confirm your selection and return to
the Presets/Sequences menu.
The display will automatically return to the Presets/Sequences menu
after 10 seconds of inactivity, and edits to the preset intensity will not
be saved.
ColorSource CYC
Page 8 of 12
ETC
