ETC ColorSource CYC, Installation Manual

Page: 9 / 12

ETC Installation Guide
ColorSource CYC v1.7/v3.1
Troubleshooting and Maintenance
Update the Fixture Software
ETC recommends using UpdaterAtor software to manage software
updates. For information on UpdaterAtor, see the
UpdaterAtor
Software Quick Guide and the UpdaterAtor Software Release Note,
which you can download from
etcconnect.com .
You can push newer software versions from a connected fixture to
selected ColorSource fixtures (see table that follows).
Note: If you have other types of fixtures in your DMX run, you
do not need to disconnect them before pushing the updated
fixture software. The update process will ignore any other fixture
types in the DMX run.
Note:
Not sure what version of fixture software is
installed? The version number appears on the display when the
fixture powers up.
This fixture...
...can push software to these fixtures/releases when connected
CYC Linear PAR Spot Spot jr
≤
v1.7 v3.1
≤
v1.7
≤
v1.7 v3.0
≤
v1.7 v3.0 v2.0 v3.0
CYC v1.7 or earlier X X X X
CYC v3.1 X
Linear v1.7 or
earlier
X X X X
PAR v1.7 or earlier X X X X
PAR v3.0 X X
Spot v1.7 or earlier X X X X
Spot v3.0 X X
Spot jr v2.0 X
Spot jr v3.0 X
1. Remove power and DMX In from the fixture that is running the
software version that you want to push to other fixtures.
2. Press and hold the Up button and Down button simultaneously
while restoring power.
3. The display shows Udt rdy
to indicate the update mode is
selected.
ColorSource CYC Page 9 of 12 ETC