eta PelletsCompact PC33, Installation Manual

Page: 46 / 76

46 www.eta.co.at
Dismantling the boiler (if required) Installation
Detaching the pellet hopper
On both sides of the pellet hopper, remove the two
M8 screws. Loosen the 4 screws for fastening to the
stoker and remove the pellet hopper.
Fig. 9-23: Pellet hopper
Make sure care that the seal between the pellet
hopper and the stoker is not damaged.
Remove stoker
Loosen the 4 M8 screws fastening the stoker to the
boiler. Then take the stoker out of the boiler.
Fig. 9-24: Stoker
Avoid damaging the seal between the boiler and
the stoker.
Fig. 9-25: Seal
Placing the boiler
Remove the extension frame from the bottom.
Fig. 9-26: Frame
Place the boiler body into the boiler room.