eta gratus expert, Instructions For Use Manual

Page: 58 / 64

Avoid contact of attachments employing sharp cutting edges/blades ( F3, D2, M7-M10, S3 )
with hard items, which could blunt them, reducing their effectiveness. If you clean these
items, pay maximum attention as they are sharp! Some foods may colour the respective
attachment to a certain extent. However this shall not have any effect on the appliance
operability and does not constitute a reason to file a complaint! The colouring will usually
spontaneously disappear after some time. Never dry plastic mouldings above a heat source
(such as stove, electric/gas oven ).
1) Multifunctional head and food processor body A
Clean them with a damp cloth soaked in water with a detergent. Avoid water getting in the
internal components! If the power cord becomes dirty, wipe it with a damp cloth.
2) Stainless bowl B1
Clean the component with a damp cloth soaked in water with a detergent. Do not use steel
wool, wire brush or bleaching agent for cleaning. Remove lime sediments with vinegar.
3) Whipping/mixing whisks and kneading hook C1, C2, C3, C4
Immediately after use, wash the attachments in hot water with a detergent and let dry out.
4) Mincer D
Immediately after use, wash the attachments in hot water with a detergent and let dry out.
After washing and drying the components, we recommend applying cooking oil on blades,
knives and exchangeable discs. For easier cleaning of mincer, mince a piece of hard
pastry (e.g. a croissant or a bun) at the end. Never wash in a dishwasher!
5) Grating M
Immediately after use, wash the attachments in hot water with a detergent and let dry out.
6) Blender F
Immediately after use, wash the attachments in hot water with a detergent and let dry out.
Knife cleaning procedure: pour about 0.5 l of clear water in the container, switch on the
appliance and remove the impurities by several pulses. In the case of larger amount of
impurities, repeat the procedure several times, or pour 1 litre of water, add a small amount
of detergent and switch on the blender for 1 minute. For easier cleaning, take the knife F3
from the blender base F2 according to Fig. 14. To release the knife F3 , use the release key F8 .
Sealing replacement procedure
Proceed according to Fig. 9 and 14. If the sealings F4 is worn or damaged, replace it with
a new one (of identical type ETA 012800400).
7) Food schopper S
Immediately after use, wash the attachments (not be washed sickle-shaped knife S3 )
in hot water with a detergent and let dry out (you can also wash the container S1 in
a dishwasher). Clean knife S3 with a soft and wet cloth with a little detergent or knife
cleaning procedure: pour about 80 ml of clear water in the container, switch on the
appliance and remove the impurities by several pulses.
Sealing replacement procedure
Proceed according to Fig. 11. If sealing S4 is worn out or damaged, replace it with a new
one (of a similar type ETA 002800985).
GB
58 / 61