eta BE-P3, Installation Manual

Page: 13 / 20

Installation Exchange for HACK VR
13
Fig. 3-25: Cutting template
After cutting out, seal the cut edges with a coating
to prevent rust from building up.
Mount new control panel
The two side tabs on the retaining plate of the new
control panel can be broken off. They are already
perforated for this purpose. Breaking off the tabs is
only necessary if the cut-out in the cover has
not been
enlarged.
Fig. 3-26: Break off tabs
Insert the new control panel and carefully attach it with
the retaining plate and two screws. Note the correct
alignment of the control panel. The ETA logo must be
on top.
Fig. 3-27: Attachment (original cut-out)
If the cut-out has been enlarged, the tabs are left
on the retaining plate.
Fig. 3-28: Attachment (enlarged cut-out)
Remove the existing USB cable. Instead of this, plug
the supplied USB cable (angled plug and socket) into
the side of the control panel and attach the socket to
the frame.
Fig. 3-29: USB cable