eta Ambo, Instructions For Use Manual

Page: 31 / 56

Adapter for a dough (biscuits)
Assembly (Fig. 6 and 6a)
Insert spiral feeder
F
into the grinder body
D
, with tooth wheel
F1
ahead. Fit separator
H
on the grinder body D . Be sure that separator scoring fits on the lugs of the grinder head.
Insert the dough adapter Q into the nut P and tighten it. Push the hoop R with different
shapes of dough profiles on the adapter Q . Attach the grinder body D to the drive unit A .
After pushing, adjust the grinder body D to vertical position till it locks, which is followed by
characteristic sound effect (knack). Set the filling hopper B on upper part of the grinder D .
Now the appliance is prepared for preparation of formed dough. At disassembly, proceed
in the contrary way. To release the grinder body, it is necessary to push the button O .
Use
Insert prepared dough to the filling hopper B . If necessary, use grinder rammer C for
slight pushing the dough into the grinder body
D
. The appliance will extrude the dough of
required set–up shape.
Plug the supply cable to socket using the socket plug A1 and push the switch N ( START/
STOP
). The operation indicator lamp
L
will light. After finishing the preparation, switch the
appliance off by the switch N ( START/STOP ).
Recommendation
We recommend to hold (support) extruded dough of required shape by a salver to prevent
tearing the dough. Formed dough shall be cut to shorter length of approximately 5 to 7 cm.
Time of preparation can take several minutes and depends on quantity, kind and quality of
used fruitage. For easier releasing the nut P , you can use the release lever (Fig. 8). Please
use the button M (reverse run) if the appliance is blocked.
Poppy seed mill (fig. 12), (CAN BE PURCHASED)
Assembly (fig. 13)
Put carrier S1 onto cover S2 . Put “fixed” grinding disc S3 onto the carrier, then start turning
with the disc slowly until the three arresting projections on the disc fit in the three created
indentations in the carrier. Now place the “moving” grinding disc (i.e. with grooves facing
each other) on the “fixed” grinding disc. Slide pusher plate S4 onto the shaft so that the
central projection faces the opening in the grinding disc. Then start turning the pusher plate
slowly until the three arresting indentations on the plate fit in the three created projections
in the disc. Finally, screw regulating disc S5 onto the carrier shaft and screw it.
Installation of the extra attachment into the drive unit
(fig. 14)
Slide the assembled poppy seed mill (with the gearwheel) onto the drive unit outlet at a 45
o
degree angle and by turning it slightly anti–clockwise, secure it in its horizontal position
(a click sound will be heard). To dismantle the assembled mill, press the appropriate
release control (e.g. button) on the drive unit, start turning the mill slightly clockwise as far
as it goes and then slide it out of the drive unit outlet.
Setting “fineness / coarseness” of grinding (fig. 15)
Fineness of grinding is set by a turning regulating disc
S5
. Turning the disc clockwise
reduces the distance between the grinding discs and thus the fineness/coarseness of
grinding can be changed.
31
GB
/ 53