2.2
Equipment Installation
2.2.1
Selection of input/output cables
Before installing the equipment, the user should confirm the model on the nameplate, select
cables of appropriate specifications according to the equipment input/output voltage and
current rating of the equipment. If the input/output current is greater than 125A, it is necessary
to select the appropriate specifications of the cold end (as shown in Figure 2-1), crimp the input
side cable and the output side cable.
Figure 2-1 Cold-pressed terminals
WARNNING
If the equipment is disassembled and installed at a low temperature, water
droplets may condense. The cabinet must be dry completely before installing the
product, otherwise, there is a risk of electrical hazards and damage to the product.
2.2.2
Installation steps
Step 1:
Remove the bottom baffle (Figure 2-2), the user can connect the PE, N, C, B, A cables on the
input side and N, C, B, A cables on the output side into the cabinet through the input side cable
entrance hole① and the output side cable entrance hole②, which are at the bottom of the
cabinet (Figure 2-3).
Figure 2-2 bottom baffle.
Figure 2-3 Entrance hole
Summary of Contents for EAC-4Q-KS 15
Page 57: ...Figure 5 14 DC output mode...
Page 97: ...CUR POW POW...
