CONNECTION
• Connect the head unit line outputs (FRONT or REAR L & R) with the MASTER AMP RCA LINE INPUTs with appropriate
RCA cables.
• Connect IN/OUT of the MASTER AMP and IN/OUT of the SLAVE AMP with an appropriate RCA cables.
• Connect the subwoofer (+) with the SPEAKER OUTPUT (+) of the MASTER AMP and the subwoofer (–) with the
SPEAKER OUTPUT (+) of the SLAVE AMP
• Connect the SPEAKER OUTPUT (–) of the MASTER AMP with the SPEAKER OUTPUT (–) of the SLAVE AMP
• Connect the PROTECT BRIDGE terminals of the MASTER AMP and SLAVE AMP with the supplied cable.
If there will be an operation fault on one of the two linked Amplifiers both will shut down.
The Amplifier with the malfunction, is detectable by the red illuminated display on the toppanel.
• The minimum final Subwoofer impedance should not be lower than 1 Ohm.
MASTER/SLAVE - SWITCH
• The selector of the MASTER AMP must be set on MASTER AMP position and the selector of the SLAVE AMP must be set
on SLAVE AMP position.
• This deactivates all related controls and switches on the SLAVE AMP and the settings of the MASTER AMP becomes
effective for the SLAVE AMP.
For all other settings see page 17.
Two 1-Channel-Monoblocks / 1 Subwoofer in Master / Slave-Mode
18
LOUDSPEAKER WIRING & CONNECTION
Monoblock Amplifier VE 1000.1 / VE 1800.1
SLAVE
AMP
MASTER
AMP
IN/OUT
LCH
RCH
LINE INPUT
LINE
SLAVE
AMP
MASTER
AMP
IN/OUT
LINE OUT
Protect
Bridge
BRIDGE
Protect
Bridge
BRIDGE
LCH
RCH
LCH
RCH
RADIO / HEAD UNIT
LINE INPUT
SUBWOOFER 2 OHM
MASTER
SLAVE
MASTER
SLAVE
Caution!
Ensure not to connect speaker (-) to the ground or vehicle chassis.
Please ensure correct polarity for all connections like indivated on the devices.
Incorrect phasing of the speakers results in total loss of bass response.
BASS REMOTE
MIN - MAX Level Controller
White LED = Operation Mode
Red LED = Protection Mode
(see page 19)
MIN MAX
LEVEL
PROTECT BRIDGE
CABLE