ESTEBAN LANTERN CMP-180, Instructions For Use Manual

Page: 9 / 36

9
REPAIR
If the product is not working properly, check the following points:
Problems / Symptoms Causes Solutions
The diffuser does not start
up or switches off during
diffusion The battery has run out or does not
have enough charge Connect the electric cable to the underside of the device
ensuring you do not tilt it if there is any water left in
the container
, and connect it to the mains. Wait until the
device battery is completely recharged (indicator n°5 switches
off)
No mist when the appliance
is switched on The appliance is not plugged in Make sure that the power adapter is properly connected to the
appliance and fully plugged in to the wall socket
Water level too low Fill the water container
Water level exceeds 160 ml Empty out excess water
The end of part
1
is obstructed Make sure that nothing is preventing the release of the mist
The chimney above the ceramic disk is
clogged up by a drop of water Using a cotton bud, remove the water drop by inserting the
cotton bud into the chimney
Mist stops while the diffuser
is in operation Water level too low Fill the water container
Accumulation of water drops in the
part
1
Switch off the diffuser, remove part
1
then clean off the
accumulated water drops
Insufficient mist The ceramic disk is dirty or clogged up
by a drop of water Clean the ceramic disk as described in the «PRECAUTION
FOR USE» instructions
An excess of Estéban refresher oils or
essential oils has been poured into the
container Empty the appliance and clean it
Accumulation of water drops in the
part
1
Switch off the diffuser, remove part
1
then clean off the
accumulated water drops
The light does not switch on Diffuser failure Bring the diffuser back to the retailer within the after-sales
service support legal deadline
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.