
Upper & Lower Belt Tracker
9
14/06/2021
Step 9.
Rotate the torque arm so the centre pivot of the guide frame is in line with the centre of the belt.
Fit the guide roller arms (including guide rollers) allowing 3-6mm gap between the belt and the
guide rollers. Ensure the guide arms are extended an equal distance from the guide frame and
tighten adjustment screws.
Step 10.
Adjust the guide arms on the upper belt tracker to the belt trough angle.
Adjust the front cross section to allow the belt to contact as close to the middle of the guide roller
as possible. Note that the torque arm must have clearance from the cross section/pivot plate.
Step 11.
Finally the grease nipples on the torque arm, front and rear cross sections should be lubricated
adequately.
Note: Regrease nipples at regular service intervals.