15
Kongsberg XE
1.
Put an appropriate test material, that means a thin paper on the table (any significant
material thickness will create a misleading offset in this wizard).
2.
Switch vacuum on.
3.
Select the
Tool
to be adjusted.
4.
Press the
Adjust Active tool
button to enter the wizard selection dialog.
5.
Select
Center Offset Adjustment
.
6.
Follow the instructions given by the wizard, step by step.
7.
Repeat the procedure for all
Tools
mounted.
Manual Adjustment
1.
Place an appropriate test material on the table, and switch
Vacuum On
.
2.
From
Tool Configuration
dialog, select one
Tool
.
3.
Press
Adjust Active Tool
to enter the
Wizard Selection Dialog
.
4.
Select
Manual Adjustment of Center Offset and Angle
.
5.
Enter value for the
Center Offset
and select
Activate
.
6.
Note that the
Tool
will move as the new value is activated.
7.
Press
Tool Override Down
, and
Jog
approximate 10 cm to make a test cut.
8.
Press
Tool Override Down
once more to lift the
Tool
.
9.
Press the
Jog
button for the return direction shortly, just to turn the
Tool
.
10.
Press
Tool Override Down
once more to lower the
Tool
, and
Jog
the same distance back.
11.
Press
Tool Override Down
once more to lift the
Tool
.
12.
The two cuts should follow exactly the same path.
13.
If exact, the
Center Offset
is correct, select
Finish
to exit.
14.
If not, modify the
Center Offset Value
and repeat from point 6.
15.8 Manual adjustment of Center Offset and angle
94
