14
Kongsberg XE
14. Job Layout
14.1 Introduction
The system can operate in either
Single Design Layout
mode or
Multi Design Layout
mode
Single Design Layout
Press the Single Design Button to select
Single Design
layout mode.
When a design is opened in this mode it is always
located relative the selected reference point. Only one
design can be placed on the table. It can be further
manipulated with
Rotation
,
Scaling
or with
Step and
repeat
.
Multi Design Layout
Press the Multi Design Button to select
Multi Design
layout mode.
When a design is opened from File view, the first design
will be located relative to the reference point as in
single design layout. The following designs will be
placed according to the settings of the Job Layout Snap
function.
If a design is opened using drag and drop, it can
dropped anywhere inside
Job View
.
The bar on top of
Job View
is showing the name of the
selected design.
Notes:
• By using the Multi Design functions, you can locate your design anywhere inside the Job
View area. The red and green “traffic light” will show if the work is inside the work area
boundaries or not.
• A combination of Multi Design and ARS is not supported.
14.2 Multi design layout functions
85
