16
Kongsberg XE
Loosen the screw for blade fixture.
Insert a new knife blade into the holder.
Carefully push the blade towards the bottom
of the slit as the screw is fixed.
Tool Adjustment
For this tool, complete the following adjustments:
These adjustments are carried out with the foot removed:
Adjustment
Description
Tool Height
See below
Lag Setting
The
Knife Lag
depends upon the
Blade Adapter
.
Nominal value is 0-3 mm.
Tool Rotation
Adjust
Tool Angle
tangential to
Moving Direction
.
Center Offset
Adjust
Tool
sideways until centered.
Tool Offset
Adjust offset relative to
Laser Pointer
.
These adjustments are carried out with the foot mounted:
Tool Height
Correct tool height relative to table top.
- The VariCut knife tool should be adjusted to a level where the foot is lifted 1 - 2 mm / 0.04 -
0.08 inches by the material.
- The procedure is as follows:
1.
Using the wizard, adjust the height until the foot is touching the surface.
2.
From that level, add the lift distance.
For more information about how to run the
Adjustment Wizards
, see the
Tool Configuration
chapter
Zero reference for the VariCut knife tool cutting depth
The cutting depth specified in the Job setup dialog is automatically adjusted.
108
