Operation 27 - Transmission Oil Level
Pull out the dipstick and wipe it with a clean cloth.
Replace the dipstick, pushing it fully home and check
that the oil reaches the upper mark on the dipstick when
it is removed again from the transmission aperture.
If necessary, top up the transmission with clean oil and
replace the breather cum filler plug/dipstick.
See Section C for correct oil grade.
Operation 28 – Hydraulic Oil Filter
Unscrew and discard the hydraulic oil filter. Install a
new filter as follows :
Clean the inlet channel and the face of the manifold.
Smear clean oil around the rubber seal of a new filter
and install on the tractor. Screw up until the faces just
meet, then tighten a further ¾ of a turn. Do not
overtighten.
Operation 29 – Footbrake Adjustment
Release the brake pedal locking latch. Disconnect the
brake linkage by removing the split pin. Jack up one
wheel and block the other three to prevent accidental
movement. Proceed as follows:
Loosen the brake adjusting screw locknut. Depress the
respective brake pedal 1.25 in. (32 mm) and lock it with
the aid of the parking brake latch. Tighten the brake
adjusting screw until the wheel starts to bind when
rotated. Loosen the screw by one full turn and tighten
the locknut. Release the parking brake latch.
Repeat on the other wheel. Reconnect the brake
linkage by re-installing the split pin.
26. Footbrake Adjustment
1.
Locknut
2. Adjusting screw
Lock the brake pedals together and road rest to ensure
that the brakes are balanced and will stop the tractor in
a straight line. If the tractor pulls to one side, adjust
until the brakes are correctly balanced.
11
SECTION B
24. Transmission oil level
1.
Breather cum filler
2.
Dipstick
1
2
25. Hydraulic Oil Filter
1.
Oil filter
23.
Engine (right-hand side)
1. Filler plug
