2A. Single Instrument Cluster
1.
Tachometer
2.
Engine coolant temperature gauge
3.
Engine Oil Pressure Warning Light
4.
Fuel Gauge
5.
LH Turn Signal Indicator
6.
RH Turn Signal Indicator
7.
Battery Charging Indicator
8.
Hazard Warning Light Switch
9.
Air Restriction Warning Light
10.
Engine Stop Control
11.
Tractor Light Switch
12.
Key Start Switch
13.
Horn Switch
14.
Hand Throttle
15.
Turn Signal Indicator Switch
16.
Plough Lamp Switch
Engine Oil Pressure Warning Light
The red warning light on the instrument panel indicates
low engine oil pressure and should extinguish immediately
after the engine is started, and is only operative with the
key start switch in the ‘ON’ position.
NOTE :
If the light comes on while engine is running,
stop the engine immediately and investigate the cause.
The light indicates low oil pressure and is not an indication
of oil level. The engine oil level must still be checked
daily by means of the dipstick.
Hand Throttle
With the engine running, pull the throttle lever rearwards
to progressively increase engine speed. Push the throttle
lever forward to decrease the engine speed.
Hazard Warning Light Switch
Press the switch to operate both turn signals
simultaneously. The switch, which is internally
illuminated, will flash in unison with the turn signals
and the turn signal indicator lights on the instrument
panel.
Indicator Ligths
s
The upper indicator light of the pair will illuminate when
headlamp main beam is selected. When either of the turn
signal is operated, the lower indicator light will flash in
unison with the turn signals.
In some territories, where only single beam (dipped
beam) headlamps are fitted, the upper indicator light
will flash in unison with the turn signals when either of
the turn signal is operated. If, however, the tractor is
also equipped with a 7 pin rear trailer socket, the lower
indicator light will flash in unison with the turn signals
of the trailer when either of the turn signal is operated.
The turn signal indicator lights will also flash in unison
with the turn signals whenever the hazard switch is
operated.
NOTE : Please check with your Authorized Dealer on
which system is fitted on your Tractor.
Tractor Lights Switch
The lights switch is of the push-pull type and has three
positions:
Fully in : lights OFF
Midway : side, rear and instrument lights ‘ON’
Fully out : side, rear, instrument and headlights ‘ON’
Engine Stop Control
Pull the stop control knob fully out and hold it in that
position to cut off the fuel supply to the injectors and
stop the engine. The knob must be pushed fully in before
restarting the engine.
SECTION A
3
2B. Instrument Panel
(Steering wheel removed)
4
7
5
3
9
2
6
1
10
11
12
13
14
15
16
8
