10.
Assemble parts to the bottom of the table top with Screws (#5) as shown in
Figure 6
,
Detail C
and
Detail D
.
a)
Align the holes in the Mounting Brackets (#25) & (#20) with Indentations in table
top assembly and secure with screws (#5) as shown. All holes in each Mounting
Bracket
must align
with Indentations in the top. See
Figure 6
and
Detail C
.
b)
Align the holes in the two U-Support Clips (#6) with Indentations in table top. Be
sure that the two U-Support Clips (#6) are positioned exactly as shown in
Figure 6
&
Detail D
.
20
25
5
5
Detail C
Note:
Indentations
in table top are small
so look closely.
6
5
Detail D
6
6
Figure
5
HARDWARE NEEDED
#8 X 9/16 Screw
(Qty. 28)
IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE
AND USE CAUTION BECAUSE YOU COULD OVER-TIGHTEN THE
HARDWARE AND STRIP SCREW IN WOOD DOING IRREPARABLE
DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
9
NOTICE
