Figure 9
IMPORTANT! Nylon washers (#5) adequately space
painted parts at all pivot points. Neglecting the use of
these washers will result in rusted parts.
NOTE: All board arms are made of rectangular tubing.
Tightening hardware too tight may damage tubing
and make adjustment of system difficult.
Figure 10
14.
Attach lower arms (#11) to Top Pole (#3), as shown in
Figure 9
, using a hex bolt (#22), two flat washers (#18),
two plastic washers (#5) and lock nut (#4).
Note: make sure lettering is right side up. Do NOT tighten
bolt (#22) at this time.
22
18
5
18
4
3
11
16.
Insert Two Tube Plugs (#9) into open ends of Lower Arms
(#11). It may be necessary to use a rubber mallet to tap them
in. See
Figure 10
.
Note:
Tube plugs may be pre-installed
22
18
5
18
4
11
15,16
9
Detail 3
10
by the factory.
15.
Secure Actuator (#16) to Lower Arms (#11) using one bolt
(#22), two flat washers (#18), two plastic washers (#5) and
one lock nut (#4). See
Figure 10
and
Detail 3
. Tighten both
bolts (#22) snug but,
do not over tighten. Board Arms
must pivot freely.
FAILURE TO FULL
Y ENGAGE THE
BOTTOM OF THE UPPER POLE TO
THE 6” MARK ON THIS BOTTOM
POLE STICKER, COULD CAUSE
YOUR UNIT TO COLLAPSE AND MAY
RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE.
BA
CK
SID
E
Bottom
of
upper
pole
must
cover
the
above
orange
portion
of
this
sticker
(6” mark).
WA
RN
ING
!
4L-8151-00
BA
CK
SID
E
FAILURE TO FULLY ENGAGE THE
BOTTOM OF THE UPPER POLE TO
THE 6” MARK ON THIS BOTTOM
POLE STICKER, COULD CAUSE
YOUR UNIT TO COLLAPSE AND MAY
RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE.
BA
CK
SID
E
Bottom
of
upper
pole
must
cover
the
above
orange
portion
of
this
sticker
(6” mark).
WA
RN
ING
!
4L-8151-00
BA
CK S
IDE
Note: Small amounts of clear tape can be used to adhere
Plastic Washers (#5) to Pole. This will make assembly easier.
