Figure 11
17.
Attach of Upper Arms (#6) to Top Pole (#3), as shown
in
two spacers (#8) and one lock nut (#4).
Note: Tighten bolts snug but, do not over tighten. Board
Arms must pivot freely.
18.
Insert two Tube Plugs (#9) into open ends of Upper Arms
(#6). It may be necessary to use a rubber mallet to tap plug
in.
Note:
Tube plugs may be pre-installed by the factory.
19.
Slide Actuator Crank (#35) onto shaft on the bottom of
Actuator (#16). Line up hole in shaft with hole in Actuator
Crank and insert Pin (#34) to secure. See
Figure 12
.
20.
To aid in the assembly of the backboard, lower the backboard,
by turning the Actuator Crank, until the lower arm makes
contact with Stop Spacer (#10).
Figure 12
6
7
18
8
18
4
9
3
16
Stop Spacer
(#10)
35
34
11
Figure
11
, using a bolt (#7), two flat washers (#18),
FAILURE TO FULL
Y ENGAGE THE
BOTTOM OF THE UPPER POLE TO
THE 6” MARK ON THIS BOTTOM
POLE STICKER, COULD CAUSE
YOUR UNIT TO COLLAPSE AND MAY
RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE.
BA
CK
SID
E
Bottom
of
upper
pole
must
cover
the
above
orange
portion
of
this
sticker
(6” mark).
WA
RN
ING
!
4L-8151-00
BA
CK
SID
E
DO NOT DUNK ON THIS UNIT .
DO NOT HANG FROM ANY PART OF THIS
UNIT , INCLUDING THE BACKBOARD, RIM,
SUPPORT BRACES OR NET
.
4L-8152-00
WAR
NING
!
