23.
24.
Place a level across rim assembly and adjust rim until it is
level. Finish tightening the four nuts.
NEVER USE RIM WITH COVERPLATE REMOVED!
Figure 14
41
27
37
28
38
4
26
32
33
40
42
42
13
Detail A
Pad #37 & #38
Screw #42
25.
Attach Rim Cover Plate (#32) using four screws (#33). See
26.
Check all nuts and bolts and make sure everything is
tightened properly.
DO NOT over tighten
pivot points,
snug is tight enough.
27.
Use the Backboard Pads (#37) and (#38) as a template and
mark the hole locations on the backboard frame. See
Figure
14
and
Detail A
.
28.
Drill 9/64" pilot holes into steel backboard frame. See
Detail A. Do not drill through both sides of tube.
29.
Secure Backboard Pads (#37) and (#38), as shown, using
screws (#42). Note: Tighten screws tight but,
do not over
tighten.
Figure 14.
Note: Cordless drill recommended for screw installation. Do
not over tighten screws causing screws to strip.
Note: To install screws, it will be easier if you use a cordless
drill with 5/16” socket driver (instead of Phillips head).
Mount Goal Assembly (#28) to Backboard, as shown in
Figure 14
, using four bolts (#41), four washers (#26), and
four locknuts (#4). Tighten fasteners, but leave them loose
enough to level rim.
DO NOT DUNK ON THIS UNIT .
DO NOT HANG FROM ANY PART OF THIS
UNIT , INCLUDING THE BACKBOARD, RIM,
SUPPORT BRACES OR NET
.
4L-8152-00
W
AR
NI
NG
!
Note: Screws (#42), used in step 29, are Self Drilling
screws and can be installed without drilling pilot holes.
However, it will be easier to install screws if you drill
9/64” pilot holes. WEAR SAFETY GLASSES if drilling holes.
Note: Make sure (#27) Rim
Pad is installed between Rim
(#28) and Backboard (#23)
23
