Esatto ECG6F, User Manual

Page: 9 / 20

Page:
09
User Manual:
INSTALLING THE COOKTOP
Cut a hole in your benchtop that corresponds with the
relevant cut-out size for your Esatto Cooktop model. Refer
to the “Your Esatto Cooktop” section of this user manual.
IMPORTANT! You must have a gap of at least 30mm
between the underside of the cooktop and any surface
below.
30mm Min.
► Carefully turn the cooktop upside down and place it on
a cushioned mat.
► Apply the sealing strip provided, around the edge of the
appliance, and remove the protective covering.
Note: It’s important not to leave a gap in the sealing
strip, whilst at the same time ensuring that no sections
overlap.
IMPORTANT! Don’t use a silicone sealant to seal the
appliance against the benchtop. This
will make it difficult to remove the
cooktop in the future should it require
servicing.
► With the cooktop still upside down, place the clamps
supplied over the holes that match the size of the
screws. There are a set of screw holes in each corner
of the cooktop. Slightly tighten each screw through the
clamp, so that the clamp is attached to the cooktop, but
loose enough that you can still adjust it’s position.
► Now carefully turn the cooktop back over and gently
lower it into the cut-out.
► On the underside of the cooktop, adjust the clamps into
a position that is suitable to secure it to your benchtop.
Now you can fully tighten the screws to secure the
cooktop into position.
(A) SEALING STRIP
(B) CLAMP (C) SCREW
IMPORTANT!
This appliance must be installed by a licenced and
authorised person and in compliance with the current
standards.
IMPORTANT!
This hob is supplied to run on natural gas only and cannot
be used on any other type of gas without modification.
Refer to the LPG conversion section within this manual.
► A regulator is required and supplied with the Cooktop
for natural gas.
► Conversion for use on LPG and other gases must only
be undertaken by a qualified and authorised person.
For information on the use of other gases, please
contact the Customer Care department. Test point
adaptor is required for LPG.
► The hob must be installed by a qualified and authorised
person, in accordance with the current edition of the
AS/NZS5601.1 Gas Installations.
► Failure to install the appliance correctly could
invalidate guarantee and lead to prosecution under the
regulations quoted above.