-- 48 --
bu12d04a
7.5
Remote control, general information
To start. we call up the main menu by pressing the MENU button. Then select the
measure menu by pressing the MEASURE button.
DIP/SPRAY. Metal cored Fe. Ar+8%CO2
From the measurement
menu. you can switch
to remote control by
pressing the REMOTE
button.
There are four types of
remote control:
22.5 Volt
134 Amp
152 in/min
REM
Digital remote control
Digital remote control is used when you want to be able to recall weld data set--ups
from the weld data memory without using the controller.
S
Aristo Control 5--program.
With 5--program remote control, you can recall five different weld data set--ups
from memory. You save them in memory slots 1--5.
You can also adjust the voltage, based on the weld program you have chosen to
recall.
Analogue remote control
With analogue remote control, you can regulate the primary parameters for the
welding process from a device other than the controller.
S
Aristo Control Synergic PAE 2.
With this type of remote control, you can increase or decrease the wire feed
speed and voltage based on the selected synergetic line.
S
ESAB PSF torch with two dials.
This torch has two dials for increasing or decreasing the wire speed and voltage
based on the selected synergetic line. Adjustments can even be made while
welding.
S
ESAB PSF torch with three programs.
This torch has a 3--position switch.
Using the switch, you can recall three different weld data set--ups ”for root beads
and fill beads, for example” from memory. The weld programs can even be
changed while welding.
7.5.1
Configuration for remote control
Under section
9.2.3.
