ESAB FABRICATOR 211i
Manual 0-5450 6-5 DISASSEMBLY PROCEDURES
6.06 Power Switch S1 and Power Cord Removal
WARNING
Read and follow safety information in Section 5.03 before proceeding with disassembly.
1. Gas inlet. Remove gas inlet from rear panel.
2. Remove The Ground Wire.
3. Remove the screws which control the supply cord.
4. Remove the two screws and push SW1 out from the rear panel.
5. Remove the two supply wires from the switch.
6. Remove the supply wires which connect to power PCB.
7. Input Power Cord ground wire filter.
Cut the tie-wrap and remove the Ferrite core from the ground wire.
8. Remove The Screw and Disconnect the pipe from gas inlet.
9. Disconnect harness from power PCB.
10. Remove Fan.
7
10
9
2
3
5
4
8
6
A-12946
1
