ESAB FABRICATOR 211i
INTRODUCTION 2-2 Manual 0-5450
2.05 Transportation Methods
!
WARNING
FALLING EQUIPMENT can cause serious
personal injury and equipment damage.
!
WARNING
FALLING EQUIPMENT can cause serious
personal injury and equipment damage.
Lift Power Source with handles built into the top of the front and
rear molded panels.
Use handcart or similar device of adequate capacity.
If using a fork lift vehicle, place and secure Power Source on a
proper skid before transporting.
2.06 User Responsibility
This equipment will perform as per the information contained
herein when installed, operated, maintained and repaired in
accordance with the instructions provided. This equipment must
be checked periodically. Defective equipment (including welding
leads) should not be used. Parts that are broken, missing, plainly
worn, distorted or contaminated, should be replaced immediate-
ly. Should such repairs or replacements become necessary, it is
recommended that such repairs be carried out by appropriately
qualified persons approved by ESAB. Advice in this regard can be
obtained by contacting an Accredited ESAB Distributor.
This equipment or any of its parts should not be altered from
standard specification without prior written approval of ESAB.
The user of this equipment shall have the sole responsibil-
ity for any malfunction which results from improper use or
unauthorized modification from standard specification, faulty
maintenance, damage or improper repair by anyone other than
appropriately qualified persons approved by ESAB.
2.07 Fabricator 211i Portable System
Package (Part No. W1004201)
• Fabricator 211i Power Source
• 12 ft. (3.6 m) Tweco Fusion 220 Amp MIG Gun
• Victor Argon Regulator / Flowmeter
• Drive Rolls:
.023"/.030" (0.6/0.8mm) "V" groove,
.023"/.035" (0.6/0.9mm)"V" groove (fitted with .035" groove
lined up) ,
.030"/.035" (0.8/0.9mm) "V" knurled for Flux Cored Wire,
• Contact Tips (1 each)
.023"(0.6mm),.030"(0.8mm),
.035"(0.9mm) (fitted)
.045"(1.1mm)
• Electrode Holder with 13 ft. (4m) lead
• Work Clamp with 10ft. (3.1m) lead
• Shielding Gas hose assembly
• 15A/20A Adapter Plug from 208/230V AC 50 Amps to 115V
Amps Circuits
• ESAB Cap
• Electrodes
• Large Spring
• Operating Manual
• DVD
A-12923
Figure 2-1: Fabricator 211i System Packaged W1004201
