Pog
ramacion_
v.00.fm -
14/3/16
START UP AND PROGRAMMING
56
Installation Guide
Radio code programming (only with RSD) and gate open/close programming (D1= “
P
”)
O
Before programming the gate open/close,
ensure the turning direction of the operator is
correct (see “Initial Conditions Programming
(D1= “
C
”)” on page 55).
The radio code programming described below is
only valid if the RSD plug-in receiver has been
installed. If a different receiver is used, programme
the radio code as described in the corresponding
instructions.
1
Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2
Press the buttons ^ and
V
until D1 shows the letter
P
flashing. Press ENTER to confirm. D2 flashes.
3
Press the buttons ^ and
V
until the required D2
parameter appears (see chart). Press ENTER to
confirm. D3 and D4 flash.
4.a
Radio code programming
(D2=
1
or D2=
2
):
• Press the transmitter button. If the code is
correctly programmed, D3-D4 stop flashing
(remain static).
4.b
Gate open/close programming
(D2=
3
):
• Press ENTER. D3-D4 stop flashing (remaining
static)
• Press the total opening button. D3-D4 flash
again whilst the operations are programmed
automatically. The gate carries out the following
movements:
–
Reset (close position search)
–
Total opening
–
Total closing
• When programming is finished, D3-D4 stop
flashing (remaining static).
5
Press ESC to return to the previous display.
Main Functions Programming (D1= “
F
”)
1
Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2
Press the buttons ^ and
V
until D1 shows the letter
F
flashing. Press ENTER to confirm. D2 flashes.
3
Press the buttons ^ and
V
until the required D2
parameter appears. Press ENTER to confirm. D3 and
D4 flash.
4
Press the buttons ^ and
V
until the required D3 and
D4 value appears (see chart). Press ENTER to
confirm.
5
Press ESC to return to the previous display.
For operation different to the options defined in this
menu, access the advanced functions menu (see
“Advanced Functions Programming (D1= “
A
”)” on
page 57).
D1
D2
D3
D4
P
1
o
ç
Total opening radio code
programming
2
o
ç
Pedestrian opening radio
code programming
3
o
ç
G a t e o p e n / c l o s e
programming
D1
D2
Parameter
D3
D4
Default option
Options or values
F
1
Operation mode
a
0
1
Automatic
0
2
x
Step-by-step
2
Standby in automatic mode
1
5
x
15 seconds
0...5. 0...9
59
= 59 sec.;
2.5
= 2 min. 50 sec., etc
3
Pedestrian opening
0
0
x
Pedestrian opening is not carried out
1
0
10% of total opening
2
0
20% of total opening
3
0
30% of total opening
4
0
40% of total opening
5
0
50% of total opening
a. For further details, see “Operation modes” on page 46.
