12
Rhythm
- This mode toggles the outputs on and off at a rate ranging from slow to very
fast (set by the
MA
control). At the same time, the output is grouped into “blocks” that get
gradually stronger. Use care with setting the level as this mode slowly grows.
Audio Modes
— For all the audio modes, an audio source must be connected to the
Audio
input jack, or the supplied microphone should be connected to the
Mic
jack. When
adjusting the audio modes, first turn up
MA
control until the LEDs are flashing fairly brightly
and then turn up the output
Level
controls. Otherwise you may get an unpleasant surprise
if the audio signal suddenly gets louder. The
MA
control — or the volume control on your
audio source — should be adjusted so the LEDs flicker from dim to bright. If it’s set too
high, the desirable effects are lost. If it’s set too low, the stimulation will be weak.
• Audio 1
- This mode is optimized for use with the
Mic
input. It picks up sounds from the
microphone and produces synchronized e-stim for both channels.
Audio 1
is ideal for
use with
Split
.
• Audio 2
- This is the stereo version of
Audio 1
and works best with the
Audio
input.
The left and right audio signals are processed independently for Channel A and Channel
B. This mode is ideal for use with a CD player or other stereo music source. Popular,
dance and other music with a defined beat tends to work best Classical or other music
with soft passages may interrupt the stimulation.
• Audio 3
- This mode is like
Audio 2
but optimized for use with computer generated
wave files — see Section A5 — but it also provides a unique effect on music and
speech. Adjust
MA
control carefully for the best effect.
Audio 3
is a TriPhase mode and
it’s especially important this mode never be used above the waist.
Split
- This mode splits the channels so you can run a different mode on each. From
the factory, Channel A is set to
Stroke
and Channel B is set to
Waves
. See Advanced —
Section A2 — for information on how to choose different selections for
Split
.
Random1
- This mode randomly selects from the first 6 modes and runs each for a
random length with
MA
value set to a random value. This provides an extremely wide
variety of stimulation.
MA
control has no effect.
Random2
- This mixes several random effects and changes them at various intervals. It’s
never the same twice!
MA
control has no effect.
Toggle
- This mode simply alternates a constant output back and forth between the two
channels.
MA
control adjusts the rate. This produces a similar effect to other e-stim devices
and many TENS units.
Orgasm
- This mode starts with a highly erotic synchronized ramp and very slowly builds
in urgency until it reaches a frantic pace and then resets and does it again.
MA
control
adjusts the pulse frequency.
Modes