Keyboard 1504M Set-up
In order to start programming press the
ESC
and
MENU
keys at the same time and enter the
password (4 digits). The default password is 0000 (four times 'zero').
In order to exit programming press the
ESC
key, and the keyboard will automatically be
re-booted in order to activate the new setting(s).
A lot of setup features are available in the 1504M, whereof most are reserved for
future use. Only the ones valid for Telemetry Receiver/E-Mux control are described in
the following.
Default settings
The main default settings are factory programmed as follows:
Keyboard type: Direct Telemetry Receiver/E-Mux control (CamCtrl)
Communication: RS485 (PTZ) and RS232 (E-Mux)
Baud rate: 2400 (PTZ) and 2400 (E-Mux).
Password: 0000
Change keyboard type
Press the key
F4
to select
CamCtrl
.
Change communication media
Press the key
F6
to select
RS485
for PTZ control (RS232 is
automatically selected for E-Mux control).
Set baud rate
Press the
F7
key to toggle between the valid baud rates for E-Mux
control. The baud rate chosen must match the one set up for
RS232 in the E-Mux (Baud rate - 2400 - is automatically selected
for RS485 PTZ control).
Set the function of the AUX keys
Press the
F9
key to get to the
AUX
menu.
Press the
F6
key to toggle between
Latch/No Latch
function.
Change the password
Press the
F9
key to get to the
Change Password
menu.
Press
F7
and enter the new password (4 digits).
Re-enter the new password.
Set the volume of the key-press beeper
Press the
F9
key to get the
Beep
menu.
Press the
F4
key to toggle between
HIGH
-
LOW
-
OFF
.
Test and re-calibrate joystick
Use this function to re-calibrate the joystick in case e.g. pan & tilts are moving although the
joystick is released.
Press the
F9
key to get the
Test joystick
menu.
Press the
F7
key to enter the test and re-calibration functions.
1504M E-Mux & PTZ control
Page 4
2821-00062
